Each Phaserunner includes an 80cm battery cable terminated with an XT60 female plug at one end and Anderson Powerpoles on the other for hookup to your battery pack. Automatic thermal rollback to prevent controller overheatingīoth models of the V3 Phaserunner use the same connectors for the Battery, Cycle Analyst, Throttle, and Communication plugs, but they differe in how they hook up to the motor.īattery - XT60:The hookup for the battery pack is with an embedded XT60 style male bullet connector.Wide Operating voltage range from 20V to 90V (21S Li-Ion, 24s LiFe).Torque based throttle command (no twitchy throttle with powerful system).Higher motor efficiency than typical trapezoidal controllers.Virtual Electronics Freewheeling allows you to experience zero drag with direct drive motors.Field Weakening allows you to run motors faster than normal back-emf limit.Fully programmable parameters (regen voltage, max phase and battery currents etc.).Works both Sensored and Sensorless, and even with very high eRPMs.Proportional regen available through throttle signal or stand alone wire.Compatible with new CA3-WP display and control device.The Phaserunner_L10 has a cable exit for compatibility with all the motors suppled by Grin with the L1019 connector, while the Phaserunner_MT is connectorized for separate cable harnesses betweeen the controller and motor. The wiring is pared down to the bare basics for a nice clutter-free installation with two models for different applications. You can power it from a 24V battery or a 72V battery, and run your phase current to peaks of over 90 amps, though the continuous current capability without additional heatsinking is typically 45-50A. This controller was designed as a universal device that can fit on almost any bicycle frame and handle almost any motor system. It is ideally suited for running brushless motors for electric vehicles in the 500-2000 watt power range, and once you have experienced the smooth response of a FOC with a torque throttle it's hard to go back to a the setup you had before. The Phaserunner is a compact state-of-the-art field oriented motor controller (FOC) from Grin Technologies based around the sophisticated control electronics from Accelerated Systems Inc.

Usb to ttl driver